Dell OptiPlex 5000 Small Form Factor - Installing the Power Button

About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Disconnect the power-button cable from the connector on the system board.
2. Press the release tabs on the power-button head and push the power button through the slot on the chassis.
3. Remove the power button and its cable from the from the slot on the chassis.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
46
Removing and installing components