Dell OptiPlex 5000 Small Form Factor - Installing the WLAN Antenna

2. Remove the two (M2x3) screws that secures the WLAN antenna to the chassis.
3. Lift and remove the WLAN antenna from the chassis.
Installing the WLAN antenna
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WLAN antenna and provides a visual representation of the installation
procedure.
Steps
1. Route the WLAN antenna cables through the routing guides on the chassis.
2. Place and align the screw holes on the WLAN antenna with the screw holes on the chassis
3. Replace the two (M2x3) screws to secure the WLAN antenna to the chassis.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the WLAN card.
Removing and installing components
51