About this task
The following image indicates the location of the Dell Ultra Speed Drive Gen 4 card and provides a visual representation of the
installation procedure.
Steps
1.
NOTE: The Dell Ultra Speed Drive Gen4 card must be installed in the PCIe x4 slot.
Align the Dell Ultra Speed Drive Gen 4 card with the PCIe x4 card slot on the system board.
2. Using the alignment post, connect the card in the connector and press down firmly.
3. Ensure that the card is firmly seated.
4. Close the expansion-card door, and press until it clicks into place.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Optional I/O modules (PS2/Serial)
Removing optional PS2 module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the heat-sink and fan assembly.
About this task
The following images indicate the location of the optional PS2 module and provides a visual representation of the removal
procedure.
Removing and installing components
67
To Next Page
Loading...
