Steps
1. Align the graphics card with the PCIe x16 card slot on the system board.
2. Using the alignment post on the PCIe slot, connect the card in the connector and press down firmly. Ensure that the card is
firmly seated.
3. Close the PCIe door.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the Dell Ultra Speed Drive Gen 4 card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the Dell Ultra Speed Drive Gen 4 card and provide a visual representation of the
removal procedure.
Steps
1. Lift the pull tab and open the expansion-card door.
2. Push and hold the securing tab on the PCIe slot and lift the Dell Ultra Speed Drive Gen 4 card from the PCIe x4 card slot.
Installing the Dell Ultra Speed Drive Gen 4 card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
66
Removing and installing components
To Next Page
Loading...
