Next steps
1. Install the hard-drive and optical-drive bracket.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Voltage regulator heat sink
Removing the voltage-regulator heat sink
Prerequisites
1. Follow the procedure in before working inside your computer.
WARNING: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the side cover.
About this task
The following image indicates the location of the voltage-regulator heat sink and provide a visual representation of the removal
procedure.
Removing and installing components
59
To Next Page
Loading...
