How to fix power rail failure on Dell Desktop?
If your Dell Desktop indicates 'Power rail failure', it means the EC ran into a power sequencing failure. If the problem persists, replace the system board.
How to fix SBIOS flash corruption on Dell OptiPlex 5090 Small Form Factor Desktop?
If your Dell Desktop shows 'SBIOS Flash corruption', it means flash corruption was detected by SBIOS. If the problem persists, replace the system board.
How to fix auxiliary device failure on Dell OptiPlex 5090 Small Form Factor?
If you Dell Desktop displays 'AUXILIARY DEVICE FAILURE', and you are using an external mouse, check the cable connection. Also, enable the Pointing Device option in the System Setup program. The touchpad or external mouse may be faulty.
What to do if bad command or file name on Dell Desktop?
If your Dell Desktop displays 'BAD COMMAND OR FILE NAME', make sure you've spelled the command correctly, used proper spacing, and provided the correct path name.
What to do if file being copied is too large for the destination drive on Dell Desktop?
If your Dell Desktop shows 'THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION DRIVE', try copying the file to a different disk or using a larger capacity disk.
Why filename cannot contain special characters on Dell Desktop?
If your Dell Desktop displays 'A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING CHARACTERS: \/:*?"| -', avoid using these characters in filenames.
How to fix drive not ready error on Dell Desktop?
If your Dell Desktop displays 'DRIVE NOT READY', install a hard drive in the hard drive bay.
How to fix memory allocation error on Dell OptiPlex 5090 Small Form Factor?
If your Dell Desktop displays 'MEMORY ALLOCATION ERROR', the software you're trying to run is conflicting with the operating system, another program, or a utility. Shut down the computer, wait for 30 seconds, and then restart it.
How to fix no timer tick interrupt on Dell OptiPlex 5090 Small Form Factor?
If your Dell Desktop displays 'NO TIMER TICK INTERRUPT', a chip on the system board may be malfunctioning. Run the System Set tests in Dell Diagnostics.
How to fix hard-disk drive configuration error on Dell Desktop?
If your Dell Desktop shows 'HARD-DISK DRIVE CONFIGURATION ERROR', the computer cannot identify the drive type. Shut down the computer, remove the hard drive, and boot the computer from an optical drive.
To Next Page
General