What does it mean if my Dell OptiPlex 5090 Small Form Factor has MEM config in process?
If your Dell Desktop has MEM config in process, the BIOS Post code is (Old LED pattern 0011). Appropriate mem modules detected, but failure has occurred.
What does 'Insert Bootable Media' mean on Dell OptiPlex 5090 Small Form Factor Desktop?
The 'Insert Bootable Media' message on your Dell Desktop indicates that the operating system is trying to boot from non-bootable media, such as an optical drive. Insert bootable media to resolve this.
What to do for hard-disk drive configuration error on Dell OptiPlex 5090 Small Form Factor?
If you encounter a hard-disk drive configuration error on your Dell Desktop, where the computer can't identify the drive type, follow these steps: Shut down the computer, remove the hard drive, and boot the computer from an optical drive. Then, shut down the computer again, reinstall the hard drive, and restart the computer. Finally, run the Hard Disk Drive tests in Dell Diagnostics.
What to do if my Dell OptiPlex 5090 Small Form Factor has decreasing available memory?
If your Dell Desktop shows decreasing available memory, it may be due to faulty or improperly seated memory modules. Reinstall the memory modules, or replace them if necessary.
What to do if Dell OptiPlex 5090 Small Form Factor shows 'Invalid Configuration Information'?
If your Dell Desktop displays 'Invalid Configuration Information', it means the system configuration information doesn't match the hardware configuration. Correct the appropriate options in the system setup program to resolve this.
What to do if Dell Desktop shows 'Extended Memory Size Has Changed'?
If your Dell Desktop shows 'Extended Memory Size Has Changed', the amount of memory recorded in NVRAM does not match the memory module installed. Restart the computer. If the error appears again, Contact Dell.
What does 'Time-of-Day Clock Lost Power' mean on Dell OptiPlex 5090 Small Form Factor Desktop?
If your Dell Desktop displays 'Time-of-Day Clock Lost Power', it means the system configuration settings are corrupted. Connect your computer to an electrical outlet to charge the battery. If the problem persists, try to restore the data by entering the System Setup program, then immediately exit the program. If the message reappears, Contact Dell.
What to do if Dell OptiPlex 5090 Small Form Factor Desktop shows 'Unexpected Interrupt in Protected Mode'?
If your Dell Desktop displays 'Unexpected Interrupt in Protected Mode', the keyboard controller may be malfunctioning, or a memory module may be loose. Run the System Memory tests and the Keyboard Controller test in Dell Diagnostics or Contact Dell.
What should I do if my Dell Water Filtration System has a CPU failure?
If you are experiencing a CPU failure with your Dell Water Filtration System, run the Intel CPU diagnostics tools. If the issue continues, consider replacing the system board.
What to do if my Dell Water Filtration System has a system board failure?
If your Dell Water Filtration System experiences a system board failure, including BIOS corruption or ROM error, flash the latest BIOS version. If the problem continues, replace the system board.
To Next Page
General