Setting up the monitor │ 35
Connecting your monitor
WARNING: Before you begin any of the procedures in this section,
fol low the Safety instructions.
NOTE: Dell monitors are designed to work optimally with Dell supplied
inbox cables. Dell does
not guarantee the video quality and performance
when using non-Dell cables.
NOTE: Route the cables through the cable-management slot before
connecting them.
NOTE: Do not connect all cables to the computer at the same time.
NOTE: The graphics are used for the purpose of illustration only. The
appearance of the computer may vary.
To connect your monitor to the computer:
1. T
urn Off your computer and disconnect the power cable.
2. Conne
ct the DisplayPort, HDMI, VGA or DVI cable from your monitor to the
computer.
3. Conne
ct the USB 3.2 Gen1 upstream port on the monitor and an appropriate
USB 3.2 Gen1 port on your computer with the supplied USB cable (see
Bottom view for details).
4. Conne
ct the USB 3.2 Gen1 peripherals to the USB 3.2 Gen1 downstream ports
on the monitor.
5. Pl
ug the power cables for your computer and monitor into a nearby outlet.
6. T
urn On the monitor and the computer.
If your monitor displays an image, installation is
complete. If it does not display
an image, see Common problems.
Connecting the DisplayPort (DisplayPort to DisplayPort) cable
To Next Page
Loading...
