Installing the WLAN Card
1 Insert the WLAN card in its slot on the computer.
2 Route the antenna cables through the routing channel and connect them to the WLAN card.
3 Align the shield and tighten the M2.0x3.0 screw to secure the WLAN card to the computer.
4 Install the:
a base cover
b battery
c battery cover
5 Follow the procedures in After working inside your computer.
Coin cell battery
Removing the coin cell battery
1 Follow the procedures in Before working inside your computer.
2 Remove the:
a battery cover
b battery
c base cover
3 To remove coin cell battery:
a Disconnect the coin cell battery cable from the computer [1].
b Pry and lift the coin cell battery from the computer [2].
Removing and installing components
17
To Next Page
Loading...
