30
Installing the Device on a Flat Surface
The device can be installed on a flat surface, such as a desk-top, if it is not installed on a rack or on
a wall. The surface must be able to support the weight of the device and the device cables.
1
Attach the self-adhesive rubber pads (provided with the device) on each marked location on
the bottom of the chassis.
2
Set the device on a flat surface, while leaving 5.08 cm (2 inches) on each side, and 12.7 cm (5
inches) at the back.
3
Ensure that the device has proper ventilation.
Installing the Device on a Wall
1
Place the supplied wall-mounting bracket on one side of the device, ensuring that the
mounting holes on the device line up to the mounting holes on the rack-mounting bracket.
The following figure illustrates where to mount the brackets.
Figure 3-3. Bracket Installation for Wall Mounting
2
Insert the supplied screws into the rack-mounting holes and tighten with a screwdriver.
3
Repeat the process for the wall-mounting bracket on the other side of the device.
4
Place the device on the wall in the location where the device is being installed.
5
On the wall mark the locations where the screws to hold the device must be prepared.
6
On the marked locations, drill the holes and place all plugs (not provided) in the holes.
To Next Page
Loading...
