50
Current
— Shows what the current status is for Jumbo Frames support.
After Reset
— Indicates the Jumbo Frames status after the next time the switch is powered on.
Enabling Jumbo Frames
1
Open the
Jumbo Frames
page.
2
Select
Enabled
in the
Jumbo Frames
field.
3
Click
Apply Changes
.
The Jumbo Frames are enabled on the device after power cycling.
Creating VLAN Membership
The
VLAN Membership
page contains a port table for assigning ports to VLANs. Ports are assigned
VLAN membership by toggling through the Port Control settings.
The
VLAN Membership
page contains fields for defining VLAN groups. The switch supports the
mapping of 4094 VLAN IDs up to 64 VLANs.
The
VLAN Membership
page also displays the VLAN ID currently defined and enables to
statically create a new VLAN. To open the
page, click
VLAN Membership
in the tree view.
Figure 6-5. VLAN Membership
Ports can have the following values:
T
— The interface is a member of a VLAN. All packets forwarded by the interface are tagged.
These packets contain VLAN information.
U
— The interface is a VLAN member. Packets forwarded by the interface are untagged.
To Next Page
Loading...
