Dell PowerConnect 28xx Systems User Guide 39
4
Starting and Configuring the Device
After completing all external connections, procede as follows:
• If the device is to be used as an unmanaged switch, there is no need for a terminal connection.
• A terminal connection is required if the device is to be used in a managed mode.
NOTE: The PowerConnect 2808 has an internal serial port.
NOTE: Before proceeding, read the release notes for this product. The release notes can be downloaded
from http://support.dell.com.
NOTE: It is recommended that you obtain the most recent revision of the user documentation from the Dell
support website at http://support.dell.com.
After completing all external connections, connect a terminal to the device to configure the device
and for other procedures. For initial configuration, the standard device configuration is performed.
To Next Page
Loading...
