Dell PowerConnect 2816 - Page 68

68 Update with your book title
• Loss of Signal — Indicates if a signal loss occurred in the cable.
•
Data Ready — The transceiver has achieved power up and data is ready.
Displaying Optical Transceiver Diagnostics Test Results Table
1 Open the Optical Transceiver Diagnostics page.
2 Click Show All .
The test is run and the Virtual Cable Test Results Table opens with the following columns:
• Temp — Internally measured transceiver temperature.
•
Voltage — Internally measured supply voltage.
•
Current — Measured TX bias current.
•
Output Power — Measured TX output power in milliwatts.
•
Input Power — Measured RX received power in milliwatts.
•
TX Fault — Transmitter fault.
Finisair transceivers do not support the transmitter fault diagnostic testing.
• LOS — Loss of signal.
•
Data Ready — The transceiver has archived power up and data is ready.
•
N/A — Not Available, N/S - Not Supported, W - Warning, E - Error.
Fiber Optic analysis feature works only on SFPs that support the digital diagnostic standard SFF-4872.