Dell PowerEdge FC630 - Installing a 1.8-Inch SSD in a 1.8-Inch SSD Carrier

Follow the safety guidelines listed in safety instructions section.
Pull the rails on the side of the carrier and lift the SSD out of the carrier.
Figure 48. Removing a 1.8-inch SSD in a 1.8-inch SSD carrier
1. SSD carrier 2. SSD
Install a 1.8-inch SSD in a 1.8-inch SSD carrier.
Related Links
Safety instructions
Installing a 1.8-inch SSD in a 1.8-inch SSD carrier
Installing a 1.8-inch SSD in a 1.8-inch SSD carrier
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the SSD from a SSD carrier to replace a faulty SSD from a SSD carrier.
1. Follow the safety guidelines listed in safety instructions section.
2. Remove a 1.8-inch SSD from a 1.8-inch SSD carrier.
Insert the SSD into the SSD carrier with the connector end of the SSD toward the back. When aligned
correctly, the back of the SSD is flush with the back of the SSD carrier.
106