Table 13. Maximum shock specifications
Maximum shock Specifications
Operating Six consecutively run shock pulses in the positive
and negative x, y, and z axes of 40 G for up to 2.3
ms.
Storage Six consecutively run shock pulses in the positive
and negative x, y, and z axes (one pulse on each
side of the system) of 71 G for up to 2 ms.
Table 14. Maximum altitude specifications
Maximum altitude Specifications
Operating 3048 m (10,000 ft).
Storage 12,000 m (39,370 ft).
Table 15. Operating temperature derating specifications
Temperature Specifications
Up to 35 °C (95 °F) Maximum temperature is reduced by 1°C/300 m
(1°F/547 ft) above 950 m (3,117 ft).
35 °C to 40 °C (95 °F to 104 °F) Maximum temperature is reduced by 1°C/175 m
(1°F/319 ft) above 950 m (3,117 ft).
40 °C to 45 °C (104 °F to 113 °F) Maximum temperature is reduced by 1°C/125 m
(1°F/228 ft) above 950 m (3,117 ft).
Particulate and gaseous contamination specifications
The following table defines the limitations that help avoid any equipment damage or failure from
particulates and gaseous contamination. If the levels of particulates or gaseous pollution exceed the
specified limitations and result in equipment damage or failure, you may need to rectify the
environmental conditions. Remediation of environmental conditions is the responsibility of the customer.
Table 16. Particulate contamination specifications
Particulate contamination Specifications
Air filtration
Data center air filtration as defined by ISO Class 8
per ISO 14644-1 with a 95% upper confidence
limit.
NOTE: This condition applies only to data
center environments. Air filtration
requirements do not apply to IT equipment
designed to be used outside a data center, in
environments such as an office or factory
floor.
22
To Next Page
Loading...
