Dell PowerEdge FC630 - Internal Dual SD Module (Optional)

CAUTION: To prevent damage to the PCIe mezzanine card, you must hold the card only by
its edges.
3. Align the two connectors on the PCIe mezzanine card with the connectors on the system board.
4. Press down the PCIe mezzanine card till the connectors on the card completely engage with the
corresponding connectors.
The retention bracket on the side of the chassis latches onto the PCIe mezzanine card.
5. Close the retention latch.
Figure 19. Installing a PCIe mezzanine card
1. PCIe mezzanine card 2. PCIe mezzanine card retention bracket
3. PCIe mezzanine card connector (2) 4. PCIe mezzanine card retention latch
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Removing the sled
Installing the sled
Removing a PCIe mezzanine card
Before working inside your system
After working inside your system
Internal dual SD module (optional)
The Internal Dual SD module (IDSDM) provides you with a redundant SD card solution. You can configure
the IDSDM for storage or as the OS boot partition. In modular servers, you can choose either a redundant
SD module mode or share one slot with the iDRAC module and the remaining slot can be used for
storage or as the OS partition.
The Internal Dual SD Module (IDSDM) card provides two SD card slots and a USB interface dedicated for
the embedded hypervisor. This card offers the following features:
75