The system should have already changed the value to reflect the newly installed memory.
NOTE: If the value is incorrect, one or more of the memory modules may not be installed
properly. Check to ensure that the memory modules are firmly seated in their sockets.
3. Run the system memory test in the system diagnostics.
Related Links
Safety instructions
Before working inside your system
Removing memory modules
After working inside your system
PCIe mezzanine card
Your system supports x16 Gen 3 PCIe mezzanine card, which provides an interface between the sled and
the PCIe switches on the FX2s enclosure.
NOTE: Ensure that the PCIe mezzanine card is set to Enabled in System Setup.
Removing a PCIe mezzanine card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
1. Open the PCIe mezzanine card retention latch by pressing the release tab on the retention latch.
2. Pull back and hold the retention bracket away from the PCIe mezzanine card.
3. Lift the end of the retention latch until the two connectors on the PCIe mezzanine card disengage
from connectors on the system board.
CAUTION: To prevent damage to the PCIe mezzanine card, you must hold the card only by
its edges.
4. Lift the PCIe mezzanine card up and away from the system.
5. Close the retention latch.
73
To Next Page
Loading...
