Figure 54. Removing a PERC H730P slim card
1. standoff (2) 2. PERC H730P slim-card cable connector
3. pull tag 4. PERC H730P slim card
5. PERC H730P release latch 6. lock and unlock icon on the PERC
H730P slim card bracket
Related Links
Safety instructions
Before working inside your system
Removing the cooling shroud
Installing a PERC H730P slim card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
1. If installed, remove the PERC H730P slim card blank.
2. Press the release latch on the side of the chassis to the unlock position.
NOTE: Ensure that all the memory module ejectors are in the closed position.
114
To Next Page
Loading...
