Dell PowerEdge R430 - Removing a Hard Drive from a Hard Drive Carrier

Figure 39. Installing a 2.5-inch hard drive into a 3.5-inch hard drive adapter
1. 3.5-inch hard drive adapter 2. screw (2)
3. 2.5-inch hard drive
Next steps
Install the 3.5-inch adapter into the 3.5-inch hard drive carrier.
Related Links
Safety instructions
Removing a 3.5-inch hot swappable hard drive adapter from a 3.5-inch hot swappable hard drive
carrier
Installing a 3.5-inch hard drive adapter into a hot swap hard drive carrier
Removing a hard drive from a hard drive carrier
Prerequisites
1. Keep the Phillips #1 screwdriver ready.
2. Remove the hot swappable hard drive carrier from the system.
Steps
1. Remove the screws from the slide rails on the hard drive carrier.
2. Lift the hard drive out of the hard drive carrier.
111