Dell PowerEdge R430 - Processor Specifications; PSU Specifications; System Battery Specifications; Expansion Bus Specifications

Table 19. Chassis weight
System Maximum weight (with all hard drives/SSDs)
PowerEdge R430 19.9 kg (43.87 lb)
Processor specifications
The PowerEdge R430 system supports up to two Intel Xeon E5-2600 v3 or Intel Xeon E5-2600 v4
product family processors.
PSU specifications
The PowerEdge R430 system supports up to two AC redundant power supply units (PSUs) and a single
AC cabled PSU.
Table 20. PSU specifications
PSU Class Heat
dissipation
(maximum)
Freque
ncy
Voltage Current
550 W AC Platinum 2107 BTU/hr 50/60
Hz
100–240 V AC,
autoranging
7.4 A-3.7 A
450 W AC Bronze 1871 BTU/hr 50/60
Hz
100–240 V AC,
autoranging
6.5 A-3.5 A
NOTE: Heat dissipation is calculated using the PSU wattage rating.
NOTE: This system is also designed to connect to the IT power systems with a phase-to-phase
voltage not exceeding 230 V.
System battery specifications
The PowerEdge R430 system supports 3 V CR2032 Lithium coin cell system battery.
Expansion bus specifications
The PowerEdge R430 system supports PCI express (PCIe) Generation 2 and 3 expansion cards, which
need to be installed on the system board using expansion card risers. This system supports two types of
expansion card risers. The following table provides the expansion card riser specifications:
Table 21. Expansion card riser specifications
Expansion card riser PCIe slots on the
riser
Height Length Link
PCIE_G3_X16 riser
Slot 1 low-profile half-length x16
Slot 2 low-profile half-length x16
PCIE_G3_X8 riser
Slot 1 full-height half-length x8
Slot 2 low-profile half-length x8
37