Dell PowerEdge R430 - Page 130

Figure 54. Removing the iDRAC port card
1. iDRAC port card holder 2. iDRAC port
3. screw (2) 4. SD vFlash media card
5. iDRAC port card 6. iDRAC port card connector
Next steps
1. Install the iDRAC port card.
2. Install the expansion card riser.
3. Install the cooling shroud.
4. If disconnected, reconnect the network cable.
5. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the expansion card riser
Installing the optional iDRAC port card
Installing the expansion card riser
Installing the cooling shroud
After working inside your system
130