Dell PowerEdge T410 - 12 Storage; Overview; Internal Hard Disk Drives; RAID Configurations

Dell
PowerEdge T410 Technical Guide 36
12 Storage
12.1 Overview
The PowerEdge T410 is available in either a cabled hard-drive chassis configuration or a hot-swap
hard-drive chassis configuration. The following hard-drive configurations are available:
 4 x 3.5‖ cabled SATA drives using the motherboard SATA connectors
 6 x 3.5‖ cabled SAS or SATA drives using an optional storage controller
 6 x 3.5‖ hot-plug SAS or SATA drives using an optional storage controller
 6 x 2.5‖ hot-plug SAS, SATA, or SSD drives using an optional storage controller
The use of 2.5‖ hard drives requires the hot-plug chassis configuration and the Dell 3.5‖ hard drive
carrier and retention kit.
Upgrading between cabled and hot-plug configurations is not possible after purchase.
12.2 Internal Hard Disk Drives
The T410 system supports up to six 2.5‖ or 3.5‖ hard disk drives. See Table 11 for information on
supported hard drives. For the most up-to-date information on supported hard drives, visit Dell.com.
Supported Hard Drives Table 11.
Form Factor
Capacity
Speed
Type
2.5‖
146GB, 300GB, 600GB, 900GB
10K
SAS
2.5‖
50GB, 100GB
N/A
SATA SSD
3.5‖
250GB, 500GB, 1TB, 2TB, 4TB
7.2K
SATA
3.5‖
500GB, 1TB, 2TB, 3TB, 4TB
7.2K
NL SAS
3.5‖
146GB, 300GB, 450GB, 600GB
15K
SAS
12.3 RAID Configurations
Table 12 details RAID configurations for the PowerEdge T410.
Factory RAID Configurations Table 12.
Factory Configuration
Non-Mixed drives
all SATA, all SAS, or
all SSD; all 2.5” or all
3.5”
Cabled/
Hot-plug
Config Type
Configs
Description
Min HDD
Max HDD
Cabled
No Hard Drive
C0A
NCZCBL
No HDD, Cabled HDD Chassis
0
0
Hot-plug
No Hard Drive
C0B
NCZ
No HDD, Hot-plug HDD Chassis
0
0
Cabled
Embedded
SATA
C1
MSTCBL
Onboard SATA Controller (ICH10R)
1
4