Dell PowerEdge T410 - Storage Controllers; SAS 6;Ir; PERC 6;I

Dell
PowerEdge T410 Technical Guide 38
Factory Configuration
Non-Mixed drives
all SATA, all SAS, or
all SSD; all 2.5” or all
3.5”
Cabled/
Hot-plug
Config Type
Cabled/ Hot-plug
Config Type
Cabled/
Hot-plug
Config
Type
Cabled
SW RAID (ICH)
C18A
MSTR0CBL
RAID 0 for 2 drives (PERC S100)
2
2
C18B
MSTR0CBL
RAID 0 for 3 and above HDDs
(PERC S100)
3
4
C19
MSTR1CBL
RAID 1 (PERC S100)
2
2
C20
MSTR10CBL
RAID 10 (PERC S100)
4
4
C21
MSTR5CBL
RAID 5 (PERC S100)
3
4
SW RAID
(Add-in Card)
C22A
ASSR0CBL
RAID 0 for 2 drives (PERC S300)
2
2
C22B
ASSR0CBL
RAID 0 for 3 and above drives
(PERC S300)
3
6
Mixed Hard Drive (SAS + SATA) Factory Configuration
Mixed SAS + SATA
Min: 2xSAS+1xSATA
Max: 2xSAS+4xSATA;
all 2.5” or 3.5”
Cabled/
Hot-plug
Config Type
Configs
Description
Min HDD
Max HDD
Hot-plug
Mix SAS and
SATA—No
RAID
C15
ASS-X
Add-in SAS/SATA RAID card, No RAID
(SAS 6/iR, PERC H200)
2xSAS +
1xSATA
2xSAS +
4xSATA
Mix SAS and
SATA—RAID 1
+ RAID 1
C16
ASSR1R1-X
Add-in SAS/SATA RAID card, RAID 1 +
RAID 1 (SAS 6/iR, PERC 6/i, PERC
H700, PERC H200)
2xSAS +
2xSATA
2xSAS +
2xSATA
Mix SAS and
SATA—RAID 1
+ RAID 5
C17
ASSR1R5-X
Add-in SAS/SATA RAID card, RAID 1 +
RAID 5 (PERC 6/i, PERC H700)
2xSAS +
3xSATA
2xSAS +
4xSATA
12.4 Storage Controllers
The PowerEdge T410 supports the storage controllers listed below. For information on card
quantities and priorities, see the Expansion Cards section in the Installing System Components
chapter of the Dell PowerEdge T410 Systems Hardware Owner’s Manual on Support.dell.com.
12.4.1 SAS 6/iR
The T410 internal SAS 6/iR HBA is an expansion card that plugs into one of the PCI Express x8 slots
(four lanes wired). It incorporates two four-channel SAS IOCs for connection to SAS or SATA hard disk
drives.
12.4.2 PERC 6/i
If you want an internal RAID solution, select the PERC 6/i or PERC H700. The PERC 6/i uses the LSI
1078 ROC (RAID on Chip) processor with a PCI Express host interface and DDR2 memory. A battery is
also available for backup.