Dell PowerVault ML6000 User Manual

Syntax: addkeygroup -groupID groupname
-groupID
The unique groupname used to identify the group in the KeyGroups.xml
file.
Example: addkeygroup -groupID keygroup1
3. Run the addkeygroupalias command.
This command creates a new alias for an existing key alias in your keystore for
addition to a specific key group ID.
Syntax: addkeygroupalias -alias aliasname -groupID groupname
-alias
The new aliasname for the key. This must be the full key name, that is,
Key00 must be entered as key000000000000000000.
-groupID
The unique groupname used to identify the group in the KeyGroups.xml
file.
Example: addkeygroupalias -alias key000000000000000000 -groupID keygroup1
Note: When using this CLI command, you can only add one key at time. This
command must be run for every individual key that needs to be added
to the key group.
4. Associate a key group with a new or existing tape drive.
a. Run the moddrive command to associate a key group with an existing tape
drive.
This command modifies tape drive information in the drive table.
Syntax: moddrive -drivename drivename -symrec alias
-drivename
drivename specifies the serial number of the tape drive.
-symrec
Specifies an alias (of the symmetric key) or a key group name for the
tape drive.
Example: moddrive -drivename 000123456789 -symrec keygroup1
b. Run the adddrive command to add a tape drive to the drive table and
associate it with a key group.
This command allows you to add a drive and associate it with a specific
key group.
Syntax: adddrive -drivename drivename -symrec alias
-drivename
drivename specifies the 12-digit serial number of the drive to be added.
Note: You must add two leading zeros (0) in front of the 10–digit serial
number to reach a total of 12 digits.
-symrec
Specifies an alias (of the symmetric key) or a groupID for the tape drive.
Example: adddrive -drivename 000123456789 -symrec keygroup1
To specify a key group as default for use when no alias is defined for a tape drive,
set the symmetrickeySet property of the configuration properties file to the
GroupID of the key group you wish to use. For example,
symmetricKeySet = keygroup1
Chapter 3. Installing the Encryption Key Manager and Keystores 3-19
|
|
|

Dell PowerVault ML6000 Specifications

General

Brand	Dell
Model	PowerVault ML6000
Category	Storage
Language	English