a. Press the SELECT button to highlight the Gateway field.
b. Press the UP or DOWN button to select the digit(s) in your library’s
Gateway address.
c. Press the SELECT button to highlight the digit(s) in your library’s Gateway
address.
d. After entering the final digits in your Gateway address, press the DOWN
button and select one of the following:
v Save - to save your network settings.
v Cancel - to cancel all of your entries and leave the settings as they were.
7. Press the SELECT button to return to the Configure menu.
8. Press the CANCEL button to return to the Main menu.
9. Press the CANCEL button to return to the home screen.
10. Power cycle the library to initialize your configuration.
Logging on to the Web User Interface
To complete the configuration of your library using the Web User Interface, follow
the steps below.
1. On your host computer, open Internet Explorer.
2. In the browser address field, enter your library’s IP Address.
3. When the login screen appears, enter the following:
v Username: admin
v Password: secure
If you have a library with only one drive, proceed to the section, “Choosing
Library Settings” on page 1-15
Choosing the Number of Logical Libraries for Your Library
If you have a 2U or 4U library with only one drive, or do not wish to partition
your library, proceed to the next section, “Choosing Library Settings” on page 1-15.
One cartridge magazine cannot be assigned to two logical libraries. If you partition
a multi-drive library, each of the magazines must be assigned to a logical library
on a magazine boundary. The entire magazine must be part of one logical library
only.
Note: If you have a 2U library with two drives, you have the capability to have
two logical libraries.
a77ug070
Figure 1-16. Log in screen on the Web User Interface
1-14 Getting Started with the Dell PowerVault TL2000 and TL4000 Tape Libraries
To Next Page
Loading...
