Choosing Drive(s) Interface Identification/Settings
1. Click Drives in the left navigation pane.
2. Select the desired settings for each drive listed (either SCSI, SAS, or Fibre
Channel). Refer to Figure 1-20.
3. Click one of the following:
v Refresh - to update the current screen
v Submit - to apply the changes made to the screen
Note:
If you have a Fiber Channel Drive connected to a AS/400 Host, direct
attached to the Fiber HBA, set the Port Type to L-Port.
a77ug094
23
Figure 1-19. Example: The 4U library Configure Library: General screen
a77ug095
Figure 1-20. The Configure Library: Drive screen
Installation 1-17
To Next Page
Loading...
