Installing the Riser 2 Module
1 Hold the blue points on the riser 2 module, and align it with the guide pins to install.
2 Press down the riser 2 module and make sure that it is seated in the PCIe slot.
3 Install the:
a Top cover
4 Follow the procedure in After working inside your computer.
Removing riser 2 blank
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Top cover
b Riser 2 module
3 To remove the riser 2 blank:
a Pull the release tab [1] to open the riser2 slot and lift out the riser2 blank from the slot [2].
Removing and installing components
69
To Next Page
Loading...
