Setting up the monitor | 27
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are connecting a stand that you
purchased from any other source, follow the setup instructions that were
included with the stand.
To attach the monitor stand:
1. Align the tabs on the stand base with the slots on the stand riser.
2. Insert the stand riser on the stand base rmly.
3. Open the screw handle at the bottom of the stand base, and rotate it clockwise
to tighten the screw rmly. Close the screw handle.
3
2
1
To Next Page
Loading...
