Dell S2425HS - Page 57

Operating the monitor | 57
If the Brightness level adjusted is above the default level over 75%, the following
message appears:
Adjusting to this value will increase power consumpiton above the default level.
Do you want to continue?
Yes
No
• When you select Yes, the power message is displayed only once.
• When you select No, the power warning message is displayed again.
• The power warning message appears again only when you do a Factory Reset
from the OSD menu.
If you press any button other than the power button, the following messages appear
depending on the selected input:
No HDMI 1 Signal form your device.
Press any key on the keyboard to wake up.
If there is no display, press the monitor joystick
to select input source.
If either HDMI 1 or HDMI 2 input is selected and the corresponding cable is not
connected, a floating dialog box as shown below appears.
No HDMI 1 Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/S2425HS
www.dell.com/S2725HS
or
No HDMI 2 Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/S2425HS
www.dell.com/S2725HS
See Troubleshooting for more information.