52 │ Operating the monitor
When you change the default setting of power saving features for the first time,
such as USB-C Charging or Other USB Charging, the following message
appears:
NOTE: If you select Yes for either of the features mentioned above, the
message will not appear the next time you change the settings of these
features. When you perform a factory reset, the message will appear
again.
You will see the following message before the Lo
ck function is activated:
NOTE: The message may slightly differ, depending on the selected
settings.
When the monitor goes into Sta
ndby mode, the following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
NOTE: The message may slightly differ, depending on the connected
input signal.
To Next Page
Loading...
