Operating the monitor │ 53
The OSD functions only in the normal operation mode. If you press any button other
than the power button during the Standby mode, the following message will appear
depending on the selected input:
Activate the computer and the monitor to gain access to the OSD.
NOTE: The message may slightly differ, depending on the connected
input signal.
If either USB-C or HDMI input is selec
ted and the corresponding cable is not
connected, a floating dialog box as shown below appears:
NOTE: The message may slightly differ, depending on the connected
input signal.
When the monitor is under HDMI input and a USB Type-C cable is connected to a
noteboo
k that supports DP Alternate Mode, if Auto Select for USB-C is enabled,
the following message appears:
To Next Page
Loading...
