Dell S4048T-ON User Manual

S4048-ON S4048-ON
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
[output omitted]
Standalone#show system | grep priority
Master priority : 0
-----------STACK BEFORE CONNECTION----------------
Stack#show system brief
Stack MAC : 00:01:e8:d5:f9:6f
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------
0 Standby online
S4048-ON
1 Management online S4048-ON
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
[output omitted]
Stack#show system stack-unit 1 | grep priority
Master priority : 0
Stack#show system stack-unit 2 | grep priority
Master priority : 0
Example of Adding a Standalone with a Lower MAC Address and Equal Priority to a Stack
Stacking LAG
When multiple links are used between stack units, Dell Networking OS automatically bundles them in a stacking LAG to provide aggregated
throughput and redundancy.
The stacking LAG is established automatically and transparently by Dell Networking OS (without user conguration) after peering is
detected and behaves as follows:
• The stacking LAG dynamically aggregates; it can lose link members or gain new links.
• Shortest path selection inside the stack: If multiple paths exist between two units in the stack, the shortest path is used.
Supported Stacking Topologies
The device supports stacking in a ring or a daisy chain topology.
Dell Networking recommends the ring topology when stacking the switches to provide redundant connectivity.
Stacking
899

Dell S4048T-ON Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Operating Temperature	32 °F to 104 °F (0 °C to 40 °C)
Ports	48 x 10GBase-T, 6 x 40GbE QSFP+
Power Supply	Dual, hot-swappable
Jumbo Frame Support	Yes
OS	Dell Networking OS