To Next PageTo Next Page
Need help?Do you have a question about the Dell S4128-ON and is the answer not in the manual?
General| Ports | 28 x 10 Gigabit Ethernet SFP+; 2 x 40 Gigabit Ethernet QSFP+ |
|---|---|
| Switching Capacity | 1.12 Tbps |
| Forwarding Rate | 833.3 Mpps |
| Power Supply | Dual, hot-swappable |
| Management | SNMP, RMON, CLI, Web-based management |
| Manageable | Yes |
| Port Quantity | 28 |
| MAC Address Table Size | 128K |
| Jumbo Frame Support | Yes |
| Rack Height | 1U |
| Power Consumption | 150 W |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Data Center Switch | Yes |
| Product Type | Switch |
| Form Factor | Rack-mountable |
| Layer | Layer 3 |
| Operating System | Dell Networking OS |
Details initial hardware setup for switches, including powering on and serial connection.
Instructions to verify firmware version and download latest updates from Dell.com/support.
Procedure to delete current configuration and reset the switch to factory default settings.
Instructions for configuring the OOB management port with IP address and subnet.
Command to set up username and password for switch access.
Guide to configure QSFP+/QSFP28 ports as 4 x 10GbE breakout ports for iSCSI.
Steps to enable switch ports, setting them to access mode individually or by range.
Enables iSCSI auto-detection, configuring Jumbo frames and flow control for storage arrays.
Saves the running configuration to startup configuration and reloads the switch.
Command to enable Data Center Bridging (DCB) functionality on the switch.
Creates a QoS policy map to trust dot1p values for traffic classification.
Configures a network QoS class map to match iSCSI traffic based on qos-group 4.
Configures network QoS policy maps for pause, PFC, and application QoS settings.
