Dell S4128-ON - Apply Policies and VLAN ID to Edge Ports; Save DCB Configuration

Configure Data Center Bridging (DCB) (optional)
15 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG3704
3.11 Apply policies and VLAN ID to all switch edge ports
OS10(config)# interface range ethernet 1/1/1-1/1/54
OS10(conf-range-eth1/1/1-1/1/54)# switchport mode trunk
OS10(conf-range-eth1/1/1-1/1/54)# switchport trunk allowed vlan <vlan-id>
OS10(conf-range-eth1/1/1-1/1/54)# service-policy input type network-qos <policy-
map-name>
OS10(conf-range-eth1/1/1-1/1/54)# service-policy output type queuing <queuing-
policy-name>
OS10(conf-range-eth1/1/1-1/1/54)# ets mode on
OS10(conf-range-eth1/1/1-1/1/54)# qos-map traffic-class <queue-map-name>
OS10(conf-range-eth1/1/1-1/1/54)# priority-flow-control mode on
OS10(conf-range-eth1/1/1-1/1/54)# exit
OS10(config)#
3.12 iSCSI enable
OS10(config)# iscsi enable
OS10(config)# iscsi session-monitoring enable
OS10(config)# exit
3.13 Save configuration
OS10# copy running-configuration startup-configuration
3.14 Show commands to verify DCBx, ETS, and PFC status on individual
ports
OS10# show lldp dcbx interface ethernet 1/1/<port-number>
OS10# show lldp dcbx interface ethernet 1/1/<port-number> pfc detail
OS10# show lldp dcbx interface ethernet 1/1/<port-number> ets detail
3.15 Configure additional switches
Repeat the commands from section 3 to configure DCB on additional switches.