Operating your monitor │ 53
OSD warning messages
When the monitor does not support a particular resolution mode, the following
message is displayed:
The current input timing is not supported by the monitor display.
Please change your input timing to 2560x1440, 60Hz or any other
Dell 2X Monitor
NOTE: The message may be slightly dierent according to the
connected input signal.
This means that the monitor cannot synchronize with the signal that it is receiving
from the computer. See Resolution specifications for the Horizontal and Vertical
frequency ranges addressable by this monitor. The recommended resolution is
2560 x 1440.
Before the DDC/CI function is disabled, the following message is displayed:
The function of adjusting display setting using PC application will be
disabled.
Do you wish to disable DDC/CI function?
Yes
No
Dell 2X Monitor
SE2X23DS
When the monitor enters the Standby Mode, the following message appears:
Dell
P2418HZ
Dell 2X Monitor
Going into Standby mode...
SE2X23DS
To Next Page
Loading...
