Next steps
1. Install the battery
2. Install the base cover
3. Install the SD card
4. Follow the procedure in after working inside your computer
Hard drive assembly
Removing the hard drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer
2. Remove the SD card
3. Remove the base cover
4. Remove the battery
Steps
1. Lift the latch and disconnect the hard drive cable from the system board [1].
2. Remove the four (M2x3) screws that secure the hard drive assembly to the palm rest and keyboard assembly [2].
3. Lift the hard drive assembly along with its cable off the palm rest and keyboard assembly [3].
30
Disassembly and reassembly
To Next Page
Loading...
