3. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
4. Slide and insert the tab of the solid-state drive into the solid-state drive slot [1,2].
5. Tighten the captive screw that secures the thermal plate to the palmrest and keyboard assembly [3].
6. Replace the single (M2x3) screw that secures the thermal plate to the palmrest and keyboard assembly [4].
Next steps
1. Connect the battery cable to the connector on the system board.
2. Replace the base cover
3. Replace the SD memory card
4. Follow the procedure in after working inside your computer
22
Removing and installing components
To Next Page
Loading...
