Dell Vostro 3491 - Display Assembly; Removing the Display Assembly

Next steps
1. Replace the battery
2. Replace the base cover
3. Replace the SD memory card
4. Follow the procedure in after working inside your computer
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in before working inside your computer
2. Remove the SD memory card
3. Remove the base cover
4. Disconnect the battery cable from the connector on the system board
5. Remove the WLAN
6. Remove the hard drive assembly
Steps
1. Peel off the tape securing the wireless antenna from the system board [1].
2. Unroute the display cable from the routing guides on the palmrest and keyboard assembly [2].
3. Unroute the display cable from the routing guides on the palmrest and keyboard assembly [3, 4].
46
Removing and installing components