1. Open the latch and disconnect the touchpad cable from the system board.
2. Disconnect the speaker cable from the system board.
3. Peel the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Note the routing of the speaker cable and remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.
NOTE:
Note the position of the rubber grommets before lifting the speakers.
5. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
Installing the speakers
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of speakers and provides a visual representation of the installation procedure.
Removing and installing components
25
To Next Page
Loading...
