Steps
1. Remove the two (M2x4) screws and the single (M1.6x4) screw that secure the right fan (FAN1) to the system board and
palm-rest and keyboard assembly.
CAUTION: Do not hold the fan assembly at the center, as it may damage the center bearing.
2. Disconnect the right fan cable from the system board.
3. Lift the right fan (FAN1) off the palm-rest and keyboard assembly.
Installing the right fan
Prerequisites
About this task
The following images indicate the location of the right fan and provides a visual representation of the installation procedure.
26
Removing and installing components
To Next Page
Loading...
