Steps
1. Place the antennas into the slots on the palm-rest and keyboard assembly.
2. Route the antenna cable through the routing guides on the palm-rest and keyboard assembly.
NOTE: Route the antenna cable under the Keyboard FFC.
3. Adhere the tapes that secure the antenna cable to the palm-rest and keyboard assembly.
4. Align the screw holes on the right antenna with the screw holes on the palm-rest and keyboard assembly.
5. Replace the four (M2x2) screws that secure the right antenna to the palm-rest and keyboard assembly.
6. Align the screw holes on the left antenna with the screw holes on the palm-rest and keyboard assembly.
7. Replace the four (M2x2)screws that secure the left antenna to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the I/O board.
4. Install the right fan.
5. Install the left fan.
6. Install the heat sink (for systems shipped with integrated graphics) or the heat sink (for systems shipped with discrete
graphics).
Removing and installing components
45
To Next Page
Loading...
