After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.
Next steps
1. Install the antennas.
2. Install the system board.
3. Install the display assembly.
4. Install the I/O board.
5. Install the right fan.
6. Install the left fan.
7. Install the heat sink (for systems shipped with integrated graphics) or the heat sink (for systems shipped with discrete
graphics).
NOTE:
The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
8. Install the M.2 2280 solid-state drive in the SSD2 slot.
9. Install the M.2 2230 solid-state drive in the SSD1 slot.
10. Install the memory module.
11. Install the battery.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.
Removing and installing components
47
To Next Page
Loading...
