108 Removing and Installing Parts
6
Replace the drive panel (see "Replacing the Drive Panel" on page 105).
7
Replace the computer cover (see "Replacing the Computer Cover" on page 125).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
8
Connect the computer and devices to electrical outlets, and turn them on.
Installing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 75.
2
Remove the computer cover (see "Removing the Computer Cover" on page 76).
3
Remove the drive panel (see "Removing the Drive Panel" on page 104).
4
Remove the existing floppy drive, if applicable (see "Removing a Floppy Drive" on page 106).
5
If no screws are attached to the new floppy drive, check the inside of the drive panel for shoulder
screws. If screws are present, attach the screws to the new drive.
1 drive release latch 2 floppy drive
1
2
book.book Page 108 Thursday, July 20, 2006 11:10 AM
To Next Page
Loading...
