124 Removing and Installing Parts
Removing the Computer Stand
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION: Your computer is heavy and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt the computer and always lift correctly to avoid injury; avoid bending over while lifting.
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to
install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the
computer.
1
Follow the procedures in "Before You Begin" on page 75.
2
Loosen the captive screw securing the stand to the base of the computer.
3
Gently slide the stand back, towards the rear of the computer, then pull the stand away from the
computer to remove it.
1 computer stand 2 captive screw
2
1
book.book Page 124 Thursday, July 20, 2006 11:10 AM
To Next Page
Loading...
