Setting Up and Using Your Computer 23
1
Turn off the computer and all attached devices:
a
Click
Start
, then click
Turn Off Computer
.
b
In the
Turn off computer
window, click
Turn off
.
The computer performs a shutdown of the operating system, and then turns off.
NOTE: Ensure that the computer is off and not in a power management mode. If you cannot shut down the
computer using the operating system, press and hold the power button for 4 seconds.
2
Disconnect the computer and all attached devices from their electrical outlets.
3
Connect the DVI or VGA connector of your monitor to the appropriate connector on the computer’s
primary graphics card:
To connect a monitor with a DVI connector, use the (white) DVI port on the primary graphics card.
To connect a monitor with a VGA connector, use the (blue) VGA port on the primary graphics card.
Connecting Two or More Monitors
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTE: In order to connect and use two or more monitors in a dual graphics card configuration, multi-GPU
technology must be disabled. To disable multi-GPU, see "Changing the Display Settings to Support Two or More
Monitors" on page 25.
primary video card
book.book Page 23 Thursday, July 20, 2006 11:10 AM
To Next Page
Loading...
