Removing and Installing Parts 83
4
Align the notch on the bottom of the module with the crossbar in the connector.
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you
apply equal force to each end of the module.
5
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
1 memory connector closest to
processor
2 securing clips (2) 3 memory connector
1
cutouts (2)
2
memory module
3
notch
4
crossbar
2
3
1
3
2
1
4
book.book Page 83 Thursday, July 20, 2006 11:10 AM
To Next Page
Loading...
