92 Removing and Installing Parts
5
Disconnect any cables connected to the card.
6
Press down the tab on the top of the card retainer at the appropriate card slot and pivot the card
retainer back through the chassis wall.
7
Press the release tab (if present) on the system board connector as you grasp the card by its top corners,
and then ease the card out of the connector.
NOTE: If the card is full-length, press the release tab on the end of the alignment guides on the fan bracket.
1 release tab 2 card retainer 3 alignment guide
4 fan bracket
1
2
3
4
book.book Page 92 Thursday, July 20, 2006 11:10 AM
To Next Page
Loading...
