Front USB Panel 67
Replacing the Front USB Panel
CAUTION: To avoid damage to the cable connectors and the cable routing clips,
carefully slide the front USB panel into the front USB panel clamp slot.
1
Follow the instructions in "Before You Begin" on page 13.
2
Align and slide the front USB panel clamps into the front USB panel
clamp slot.
3
Replace the screw that secures the front USB panel to the front panel.
4
Connect the front USB panel cables to the system board connector
F_USB2 (see "System Board Components" on page 10).
5
Replace the front bezel (see "Replacing the Front Bezel" on page 29).
6
Replace the computer cover (see "Replacing the Computer Cover" on page 18).
7
Connect your computer and devices to electrical outlets, and turn them on.
book.book Page 67 Wednesday, April 25, 2012 12:34 PM
To Next Page
Loading...
