Power Supply 95
Replacing the Power Supply
1
Follow the instructions in "Before You Begin" on page 13.
2
Slide the power supply towards the back of the chassis.
3
Align the screw holes on the power supply with the screw holes on the
chassis.
WARNING: Failure to replace and tighten all screws may cause electrical shock
as these screws are a key part of the system grounding.
4
Replace the four screws that secure the power supply to the chassis.
5
Connect the DC power cables to the system board and drives (see "System
Board Components" on page 10).
6
Replace the computer cover (see "Replacing the Computer Cover" on
page 18).
7
Connect your computer and devices to electrical outlets, and turn them
on.
book.book Page 95 Wednesday, April 25, 2012 12:34 PM
To Next Page
Loading...
