Bluetooth Assembly 71
Replacing the Bluetooth Assembly
1
Follow the instructions in "Before You Begin" on page 13.
2
Slide the Bluetooth assembly cable through the slot on the front panel.
3
Align the Bluetooth assembly tab with the Bluetooth assembly slot in the
front panel.
4
Press in on the Bluetooth assembly tab, and push it towards the front panel
until it clicks into place.
5
Connect the Bluetooth assembly cable to the system board connector,
F_USB4 (see "System Board Components" on page 10).
6
Replace the front bezel (see "Replacing the Front Bezel" on page 29).
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 18).
8
Connect your computer and devices to electrical outlets, and turn them on.
book.book Page 71 Wednesday, April 25, 2012 12:34 PM
To Next Page
Loading...
